-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueBreaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Effects of Surface Roughness on High-Speed PCBs
At frequencies below 1GHz, the effect of copper surface roughness on dielectric loss is negligible. However, as frequency increases, the skin effect drives the current into the surface of the copper, dramatically increasing loss. When the copper surface is rough, the effective conductor length extends as current follows along the contours of the surface up and down with the topography of the copper surface. At high frequencies, the effective resistance of the copper increases relative to the additional distance over which the current must transverse the contours of the surface. The total loss comprises of the sum of the conductor loss and dielectric loss.
Whilst it may be possible to manufacture copper foil with a perfect mirror-smooth finish, the foil-to-resin adhesion would be compromised. This would considerably increase the possibility of delamination during the thermal stress of the PCB fabrication and assembly processes. For this reason, a reduced oxide coating is applied to the inner core layers to promote adhesion of the prepreg resin as it flows under the applied heat and pressure to cure.
Skin effect is the tendency of an alternating current to become distributed within a conductor such that the current density is largest near the surface, and decreases with greater depths in the conductor. The higher the frequency, the greater the tendency for current to take the path of lower inductance on the outer surface of the conductor.
More Columns from Beyond Design
Beyond Design: The Art of Presenting PCB Design CoursesBeyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities
Beyond Design: Balancing Trade-offs for Optimal PCB Design