The Power of Three: A Solder Mask Solution for North America


Reading time ( words)

Technology and process developments in mature industries like the printed wiring board industry are not always easy. Many new products are evolutionary enhancements of existing processes. Often, these developments enhance the process and improve overall process control.

The concept for direct digital imaging, as an example, has been around for some time, beginning in the early 1980s. Early pioneers were Excellon Automation and Eocom, in Orange County. At that time the industry was entrenched with dry film photo imaging and, at least in the North American market, there was little interest in pioneering a concept as revolutionary as direct imaging along with its attendant issues of cleanrooms and other environmental aspects. Dry film was viewed as a more robust application. Market adoption of liquid resist was also tempered by the high cost of the liquid material versus dry film.

Often, the equipment provider has a visionary leader who brings technology changes forward, but the collaboration between the equipment provider and the consumable supplier is often not a close one, or it’s nonexistent.

As digital technology started to penetrate other applications, for example, digital cameras, the vision of lowering costs and improving image quality began to take hold. But the equipment was, and still is, very expensive and requires high-cost service contracts. Nonetheless, fabricator after fabricator began embracing the newer product offerings for primary imaging, but not solder mask, which was an entirely different requirement.

Taiyo, as the leading supplier of liquid solder mask products in North America, also had a visionary concept moving forward. During IPC APEX EXPO 2016, executives from Taiyo and Schmoll sat together and worked out a testing plan that Taiyo would implement to develop a solder mask product that met the North American marketplace needs.

Schmoll provided the equipment for the testing and development, Taiyo the development protocol, and Burkle North America the installation and maintenance expertise. The result is a solder mask product and process that is being introduced during IPC APEX EXPO 2017.

 

Editor's Note: This article originally appeared in the February 2017 issue of The PCB Magazine.

 

 

Share

Print


Suggested Items

Future Trends in Flying Probe Testing

11/29/2019 | I-Connect007 Editorial Team
Peter Brandt, director of sales for Europe and Japan at atg, sits down with Pete Starkey and Barry Matties, gives his views on market requirements and testing technologies, and explains how flying probe testing is becoming the industry standard at all levels of production—and in many cases, the only practicable solution.

EIPC Winter Conference—Speakers and Papers

11/25/2019 | Andy Shaughnessy, I-Connect007
I recently spoke with Kirsten Smit-Westenberg, executive director of EIPC, who is planning the EIPC winter conference set for February 2020 in Rotterdam, Netherlands. Kirsten discusses the conference topics, which are based around the needs of the next-generation electronic devices, and changes in fabrication solutions for PCBs, PCBAs, materials, and technologies.

Flex Standards Update With Nick Koop

11/21/2019 | Andy Shaughnessy, Design007 Magazine
This month, I interviewed Nick Koop—director of flex technology at TTM Technologies, a veteran “flex guy” and instructor, and a leader of several IPC flex standards committees. Nick provides an update for the committees he’s involved with and discusses some of the challenges that he sees as more designers enter the world of flex.



Copyright © 2019 I-Connect007. All rights reserved.