The Counterfeit Epidemic That Can Kill

Reading time ( words)

In August 2011, a prime contractor warned the United States Navy that there were suspect, reworked parts that should never have been placed on one of their aircraft and that should be replaced immediately.

How is it possible a trusted, world-renowned manufacturer detected that it had installed a suspect or fraudulent part in its aircraft? The prime had subcontracted with another sub-prime contractor, who was retained to produce ice detection systems for the aircraft.

In a message to the U.S. Navy marked “Priority: Critical,” the company blamed the part, a Xilinx field programmable gate array, for the failure. This critical component was not bought from Xilinx direct or from one of their authorized distributors. Rather, this suspect part was traced upstream within the supply chain and had made its way through independent distributors in California, Florida, Japan, and China.

If you are thinking that perhaps this is an anomaly, consider this. The U.S. Senate Armed Services Committee investigation revealed that more than 1 million counterfeit components likely exist within the U.S. military supply chain. If the supply chain of the finest military in the world can be infiltrated by 1 million counterfeit components, it’s more than likely it can happen to your supply chain.

Read the full column here.


Editor's Note: This column originally appeared in the February 2014 issue of SMT Magazine.

06/07/2023 | Barry Matties, I-Connect007

As the definition of sustainably evolves in the industry, one thing is clear: Process control plays a large role in any definition. Creating a stable process reduces the potential overuse of cleaning materials and increases yields, thereby reducing scrap, and helping the sustainability effort. I recently talked with Tom Forsythe, executive vice president of KYZEN, about the cleaning process and automated bath control.

04/25/2023 | Barry Matties, I-Connect007

At the recent SMTA Boise Expo & Tech Forum, Barry Matties spoke with Doug Holtz, national sales manager of Conductive Containers, about challenges related to ESD and where manufacturers are most vulnerable. It’s a growing concern, Doug says, and there are important lessons to be learned. Doug also reviews his presentation, and he points out how reducing touchpoints in the supply chain can make a world of difference for both customers and manufacturers.

04/05/2023 | Barry Matties, I-Connect007

Barry Matties stopped by the Austin American Technology booth at the recent SMTA Dallas Expo and chatted with business development director Justin Worden about the need to clean “no-clean” flux and how maybe a name change when it was introduced might have staved off some of the confusion. Justin also talks about how a round of golf led to his entry into the printed circuit board industry.