What is 4-Wire Kelvin?


Reading time ( words)

I’ve been asked many times, “What is 4-Wire Kelvin?” So, this month I will explain the 4-Wire Kelvin Test and how it can help uncover defects that normally would go undetected in standard electrical test methodology.

Most of us have used an ohmmeter to measure voltage, resistance, and current. The typical meter has two wires; you probe the two terminals, trace ends or put the leads in line with the circuit for measuring current. A standard ohmmeter is shown in Figure 1 below.

However, with this type of measurement, the resistance of the leads and contact are added to the measurement. In Figure 2 you can see that the two leads with 0.5 ohms of resistance are added to resistance of the resistor being measure and providing a final result of 2.0 ohms, where the expected reading would be 1.0 ohms.

4-Wire Kelvin

4-Wire Kelvin testing is a methodology where high resolution measurements are taken to determine finite changes in resistance. These finite changes in resistance can then be used to locate plating defects or variations in plating thickness. The Kelvin test is highly accurate because of a four terminal system that negates all current sources, lead and contact resistances. This allows for the finite measurements to only be measured on the PCB circuitry. Typically these measurements are in the milliohm range. Figure 3 shows the typical Kelvin circuit.

Now the question, “What can Kelvin detect?” In the PCB industry, the main focus of the Kelvin test is to identify plating defects in the drilled holes.  The higher the aspect ratio of the drilled hole the higher risk of defect. The defects shown in Figure 4 are typically what you will detect using 4-Wire Kelvin. Using standard electrical test with continuity thresholds at 10 ohms (IPC Class 3), these defects will go undetected as the change in resistance introduced by these defects will not cause enough change to fault at the 10 Ohm range. However, using the Kelvin test these changes in resistance will be detected as the changes although may be only 100 to 300 milliohms the high resolution measurement will fail.

Read the full column here.


Editor's Note: This column originally appeared in the October 2014 issue of The PCB Magazine.

Share

Print


Suggested Items

I-Connect007 Survey Details Concerns About Future of Industry

04/28/2020 | I-Connect007 Research Team
I-Connect007 continues to monitor the current worldwide economic situation by seeking input from our market leaders. Here’s what we discovered: If you’re feeling the pressure, you’re not alone. In a recent survey, we asked about your primary concerns for the future of our industry. The number one concern (26%) indicated a belief that sales will be affected negatively in the coming months.

Dr. John Mitchell: IPC’s Ongoing Efforts Related to COVID-19

04/15/2020 | Barry Matties, I-Connect007
On April 14, IPC president and CEO, Dr. John Mitchell, described IPC’s ongoing efforts related to COVID-19 with I-Connect007 Publisher Barry Matties. From a standpoint approximately 30 days into the U.S. shutdown, Mitchell reported that 94% of the executives attending the executive forum are expressing concern. He also outlined many of the chaotic drivers and influences in the industry, including shifting over to different, mandated products; supply shortages; potential declining demand for normal products; and increased shipping costs. Worker and staffing shortages have also become an emerging concern.

Todd Kolmodin: Gardien an Essential Business for U.S. DoD Work

03/30/2020 | Nolan Johnson, PCB007
Todd Kolmodin, VP of quality for Gardien Services USA, updates Nolan Johnson on Gardien’s operations. Specifics include Gardien’s certification as an essential business for U.S. Department of Defense work and an overview of the work and staffing policies in place at all of the company's facilities across the United States and the various work restrictions—all with the goal of “keeping the wheels turning” in the industry.



Copyright © 2020 I-Connect007. All rights reserved.