Design for Profitability: Avoiding Fabrication Issues and Minimizing Costly Revisions


Reading time ( words)

Note that I use the term “design for profitability,” or DFP, as opposed to any of the other acronyms such as DFM (design for manufacturability), DFT (design for test), or DFA (design for assembly). I’m taking this approach because it really all comes down to profit, doesn’t it?

Designers have the power to design profit into the board, or, conversely, inadvertently increase costs and remove profit from the PCB. In this article I am going to go over just a few of the challenges that fabricators routinely face and some typical solutions, especially solutions that can affect your bottom line.

I will start with DFM. Generally, this is the first stage for prototyping and DFM depends greatly on the capabilities of your chosen fab shop. Some designs are finished with autorouters after the critical traces have been hand-placed. It is at this point that unintended issues can arise between design and fab.

An example of this is same net-spacing violations where a track may “double back” near a surface mounted component, creating same-net spacing violations (Figure 1). Whereas the software does not see these as legit violations because they are same net, a fabricator knows that any features creating spaces below 0.003” can easily flake off at the image stage and create havoc elsewhere in the form of shorts. Edit time must be taken at the fab stage when these same-net spacing violations occur and the slivers eliminated. Some CAM software packages have a sliver fill option, but again this requires additional edit time at CAM.

Read the full article here.


Editor's Note: This article originally appeared in the March 2013 issue of The PCB Design Magazine.

Share

Print


Suggested Items

EMA President Manny Marcano: EDA Tools Are Essential

04/03/2020 | Andy Shaughnessy, I-Connect007
In this interview, Editor Andy Shaughnessy speaks with Manny Marcano, president of EMA EDA Automation, who shares an update on the company's current level of business operations under COVID-19 restrictions. Marcano explains that EMA is classified as an essential business due to its work with the defense segment and that employees are now working from home. He also discusses the company's free work-from-home license offer and why he is available to help any designers or design engineers who have questions during these changing times.

This Month in Design007 Magazine: Mentor—Managing Small Problems for Profitability

03/26/2020 | Andy Shaughnessy, I-Connect007
At DesignCon, I met up with Todd Westerhoff, product marketing manager for highspeed design at Mentor, a Siemens Business, to discuss common design profitability issues and cost-aware PCB design. He explains how simple problems can “slip through the cracks” and cause delays, what you can do, and how first-order analysis can make simulation accessible to designers who wouldn’t simulate otherwise.

Design007 Survey: Profitability in Your Design Process

03/12/2020 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What part does profitability play in your PCB design planning process? Here are a few of the comments, edited slightly for clarity.



Copyright © 2020 I-Connect007. All rights reserved.