OSP and Selective Electroless Nickel for Mixed-Metal Finish PWBs and BGA Substrates


Reading time ( words)

The documentation relating to the requirements for alternative surface finishes have been well publicized at many industry forums. Pressure to eliminate lead in electronics assemblies is forcing fabricators and OEMs to reevaluate their surface finish and joint attachment procedures. Many of the requirements, in fact, are obvious. Regardless, the PWB fabrication industry needs to work closely with contract manufacturers and end users to fully appreciate the true impact of technology trends. These trends are significant and include:

  • Surface mount continues to increase at the expense of through-hole with finer and finer features.
  • The use of non-tin/lead coatings and surface finishes will increase. Surface finishes such as electroless nickel/immersion gold, OSP and immersion tin will be utilized.
  • With political movements toward banning lead in all electronic assemblies gaining significant  momentum, lead-free solder pastes and wave solder materials will be adopted.
  • The need for more robust solderable finishes under extreme environmental conditions including corrosive atmospheres.
  • The alternative surface finishes must perform through multiple thermal cycles with less active pastes and fluxes.
  • The use of multiple metal finishes on the same bare board will place new emphasis on the compatibility of coating with each other, and the actual assembly module.
  • Increased I/O demand and reduced lead pitch will require much tighter controls over the processes used to fabricate the bare board.

Read the full article here.

Editor’s Note: This article originally appeared in the February 2015 issue of The PCB Magazine

Share

Print


Suggested Items

Real Time with… AltiumLive Europe: If You Don’t Know How It’s Made, How Can You Possibly Design It?

10/26/2020 | Pete Starkey, I-Connect007
Designers attending the AltiumLive Europe 2020 Virtual Summit had the opportunity to see at first-hand how circuit boards were made to help them make informed design-for-manufacturing decisions. Pete Starkey details how Würth Electronik welcomed AltiumLive to its Niedernhall factory to take a virtual tour.

EIPC Technical Snapshot: Automotive Technology

10/19/2020 | Pete Starkey, I-Connect007
Although current circumstances have forced the postponement of its live conferences, seminars, and workshops, EIPC continues to provide a platform for the exchange and dissemination of the latest knowledge and technical information to the European interconnection and packaging industry. Pete Starkey details how its current series of technical snapshots, delivered in a webinar format, address technology challenges facing the automotive, telecom, and high-speed sectors of the industry.

Real Time with… AltiumLive 2020: Würth Virtual Factory Tour

10/13/2020 | Dan Feinberg, Technology Editor, I-Connect007
Since AltiumLive this year is a virtual event, coverage is limited to watching some of the presentations virtually. Dan Feinberg describes how he was pleasantly surprised with the quality and excellence of the Würth virtual factory tour.



Copyright © 2020 I-Connect007. All rights reserved.