Breaking High-speed Material Constraints: Design007 Magazine — May 2024
May 14, 2024 | I-Connect007 Editorial TeamEstimated reading time: Less than a minute
The world of PCB materials used to be a fairly simple one. It was divided into two groups: the “traditional” laminates and the high-speed laminates developed especially for high-speed PCBs.
But then traditional laminates started getting better, and high-speed designers and design engineers took notice. The resin systems have improved to the point that designers are now using flavors of FR-4 for some high-speed PCBs, saving time and money, while streamlining the fab process. In this issue of Design007 Magazine, our contributors explain how to avoid overconstraining your materials when working with high-speed boards. Don’t miss it.
Suggested Items
Beyond Design: Dielectric Material Selection Guide
05/23/2024 | Barry Olney -- Column: Beyond DesignMaterials used for the fabrication of multilayer PCBs absorb high frequencies and reduce edge rates. That loss in the transmission line is a major cause of signal degradation. However, not all of us are designing cutting-edge boards and sometimes we tend to over-specify requirements that can lead to inflated production costs. In this month’s column, I will look at the types of materials commonly used for PCB design and how to select an adequate material to minimize costs.
Inmarsat Launches NexusWave: A Game-Changing ‘Bonded’ Network Service For Maritime Communications
05/20/2024 | InmarsatInmarsat Maritime, a Viasat company, has launched NexusWave, a fully managed connectivity service underpinned by a ‘bonded’ multi-dimensional network, offering high-speed connectivity, unlimited data, global coverage, and ‘secure by design’ infrastructure.
The Shaughnessy Report: Unlock Your High-speed Material Constraints
05/15/2024 | Andy Shaughnessy -- Column: The Shaughnessy ReportThe world of PCB materials used to be a fairly simple one. It was divided into two groups: the “traditional” laminates, often called FR-4, and the high-speed laminates developed especially for high-speed PCBs. These were two worlds that usually didn’t collide. But then traditional laminates started getting better, and high-speed designers and design engineers took notice and started to reconsider what FR-4 could be used for.
Real Time with… IPC APEX EXPO 2024: Ventec Discusses New Pro-bond Family of Advanced Products
05/01/2024 | Real Time with...IPC APEX EXPOChris Hanson, Ventec's Global Head of IMS Technology, outlines the launch of four pro-bond formulas that deliver an outstanding combination of low dissipation factor (Df) with a dielectric constant (Dk) range to maximize the design window for critical PCB parameters. As Chris points out, Pro-bond is designed for low-loss, high-speed applications, while thermal-bond dissipates heat from a component through the board to a heat sink.
Siemens’ Breakthrough Veloce CS Transforms Emulation and Prototyping with Three Novel Products
04/24/2024 | Siemens Digital Industries SoftwareSiemens Digital Industries Software launched the Veloce™ CS hardware-assisted verification and validation system. In a first for the EDA (Electronic Design Automation) industry, Veloce CS incorporates hardware emulation, enterprise prototyping and software prototyping and is built on two highly advanced integrated circuits (ICs) – Siemens’ new, purpose-built Crystal accelerator chip for emulation and the AMD Versal™ Premium VP1902 FPGA adaptive SoC (System-on-a-chip) for enterprise and software prototyping.
Copyright © 2024 I-Connect007 | IPC Publishing Group Inc. All rights reserved.
Log in