Lead-free Reflow for High-layer-count PCBs


Reading time ( words)

This article is an update of the Holden-Carano article originally published in the February 2013 issue of The PCB Magazine.

Abstract

One of the most difficult printed circuit boards to adapt to Pb-free assembly processes is the high-layer count multilayer. Often, these multilayers have through-hole and hand-soldered components, and requirements for two or more rework cycles. The higher reflow temperatures and slower wetting of lead-free solders place an enormous strain on the laminate and copper-plated hole barrel. In many cases, the boards cannot be assembled reliably even with newer, higher thermal performance FR-4s. 

One solution to this problem is to redesign the multilayer using current design rules and newer innovative fabrication technologies. This article will review four of these new and enabling technologies:

  • Laser-drilled microvias;                                                        
  • Routing BGA using channels;
  • Contribution of new SMT connectors; and                               
  • Layer assignment changes (architectures).


Microvias offer the most significant opportunity to reduce not only the layers and thicknesses of multilayers, but also their cost while improving their electrical performance and density. Several examples will illustrate these new opportunities. Since blind vias are surface phenomena, to get the maximum benefit from them, layer assignment for signal, ground and power need to be reviewed and alternative constructions considered. These blind vias, by reducing the number of through-holes, contribute to increase routing density that allows the lower layer usage. Finally, by replacing through-hole connectors with surface mount connectors, higher connector density and improved electrical performance can be realized.

The resulting new multilayers are not only thinner, cheaper, and easier to design, but are less costly and suitable for lead-free assembly.

Read the full article here.


Editor's Note: This article originally appeared in the April 2014 issue of The PCB Magazine.

Share

Print


Suggested Items

Benchmarking Your Process Engineering

04/29/2021 | I-Connect007 Editorial Team
Mark Thompson has been in bare board fabrication for over 30 years. He is now laying out printed circuit boards at Monsoon Solutions, a high-tech design bureau near Seattle, Washington. With Mark’s extensive hands-on knowledge of PCB manufacturing, he brings a unique perspective to PCB design. In this discussion with the I-Connect007 editorial team, Mark shares what’s important from a process engineer’s point of view, and how to stay on top of evaluating and benchmarking your manufacturing process, along with insights from his new role as a designer.

Isola Releases IS550H Material

04/26/2021 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Michael Gay of Isola and Chris Hunrath of Insulectro about the release of their new halogen-free, high-thermal reliability material, which they hope fills the gap in the market between epoxies and polyimides.

EIPC Technical Snapshot: Supply Chain and Material Price Pressures

04/26/2021 | Pete Starkey, I-Connect007
EIPC’s seventh Technical Snapshot webinar on April 14 was timely and appropriate. In the context of current supply chain issues and material price pressures facing the PCB industry, particularly in Europe, the EIPC team brought together an outstanding group of experts—each a leading authority in his field—to analyse and comment upon the areas of concern and to respond to questions raised by a capacity audience. As Alun Morgan said, “If you don’t use the European supply chain, you won’t have it anymore!”



Copyright © 2021 I-Connect007. All rights reserved.