FAQ - Microwave PCB Materials


Reading time ( words)

The landscape of specialty materials changes so quickly that it can be hard for product developers to keep up. As a result, PCB designers are inundated with data about microwave PCB materials. But very often, it’s difficult to find useful information regarding these specialty substrates. So, this month, we present some of the most frequently asked questions about microwave materials encountered at Rogers.

Q:  At what frequency is it necessary to transition from FR-4 types of materials to high-frequency circuit materials?

A:  This is a challenging question to answer because different technologies can tolerate more or less performance from a laminate. I’ll give a few examples and basic guidelines.

Semiconductor technology has developed enhanced signal processing to the point where a FR-4 material could be used at higher speeds and frequencies than was once thought possible. In most cases where high-speed digital applications reach 10 Gbps or more, you will need to use a high-frequency laminate. There are exceptions, and in some cases a lower data rate PCB will also demand a high-frequency laminate.

High-frequency RF circuits, which are less concerned with insertion loss, could use FR-4 in some of these applications. However, high-frequency laminates offer more than just low loss; they provide very well-controlled dielectric constant. In many RF applications, the control of dielectric constant for the material can be as critical as substrate thickness control. As a general statement, FR-4 materials are typically not used above 3 GHz in RF applications due to insertion loss concerns. However, when dielectric constant control is a critical concern, high-frequency materials should be used instead of FR-4 materials.

Read the full column here.


Editor's Note: This column originally appeared in the February 2014 issue of The PCB Design Magazine.

Share

Print


Suggested Items

Why We Simulate

04/29/2021 | Bill Hargin, Z-zero
When Bill Hargin was cutting his teeth in high-speed PCB design some 25 years ago, speeds were slow, layer counts were low, dielectric constants and loss tangents were high, design margins were wide, copper roughness didn’t matter, and glass-weave styles didn’t matter. Dielectrics were called “FR-4” and their properties didn’t matter much. A fast PCI bus operated at just 66 MHz. Times have certainly changed.

DFM 101: PCB Materials

04/30/2021 | Anaya Vardya, American Standard Circuits
One of the biggest challenges facing PCB designers is understanding the cost drivers in the PCB manufacturing process. This article is the first in a series that will discuss these cost drivers (from the PCB manufacturer’s perspective) and the design decisions that will impact product reliability.

Mentor and Z-zero Collaborate on New Stackup Tool

09/17/2020 | Andy Shaughnessy, Design007 Magazine
I recently spoke with Max Clark, business unit manager with Mentor, a Siemens Business, and Z-zero founder Bill Hargin about the newly formed partnership that resulted in a new stackup tool that Mentor is now selling worldwide. Fun fact: Hargin used to work for Mentor as part of the HyperLynx team, which now has an interface with Z-planner Enterprise. Talk about coming full circle.



Copyright © 2021 I-Connect007. All rights reserved.