Effective Characteristic Impedance


Reading time ( words)

In a typical interconnect, there lie multiple places where capacitance plays a factor in the signal integrity. This includes the driver and receiver output/input capacitance, as well as the packages, vias, and the transmission lines. Failing to optimize these parameters can often lead to unwanted reflections, excessive radiated and or conducted emissions, and sometimes failure of components and systems.

Reflections can occur anytime there is an impedance mismatch on the line. Sources of mismatches are plentiful and include trace width changes, vias, stubs, reference plane changes, and even the so-called fiber weave effect. In this case, a trace can encounter a different dielectric constant depending on whether it is routed over glass or the epoxy resin in the dielectric material. 

In this investigation, it is the capacitive contribution of the different components that are of interest, and how they affect the characteristic impedance the driver sees. 

To read the rest of this article, click here.

Share

Print


Suggested Items

Combatting Thermal Challenges With TRM Software

10/07/2020 | I-Connect007 Editorial Team
Johannes Adam is the creator of a simulation tool called Thermal Risk Management (TRM) used to help PCB designers and design engineers predict hot spots on the board before during layout. He and Douglas Brooks, founder of UltraCAD Design, have used the tool to produce several technical articles and a book on the subject. In this interview, they tackle the biggest misconceptions they see from designers and engineers who deal with thermal management issues.

Stop Relating Trace Temperature to Current Density

10/01/2020 | Douglas G. Brooks, PhD
Many design engineers and even many software suppliers make the significant mistake of equating changes in trace or via temperature with current density. This is incorrect at best and dangerous at worst. There is little if any correlation between temperature and current density. Current and trace dimensions (among other things) are the relevant variables, but current density is not. I hope by the end of this article you will see why. Here are four illustrations that will help you understand this.

Freedom CAD’s Expert PCB Design Tips, Part 1

05/01/2020 | I-Connect007 Editorial Team
When you’re designing complex PCBs, knowledge truly is power. The more PCB design tips, tricks, and techniques you know, the better your cutting-edge designs will be. With that in mind, we’re bringing you a series of PCB design tips, courtesy of Freedom CAD Services.



Copyright © 2021 I-Connect007. All rights reserved.