Engineered Materials Systems Debuts New Conductive Adhesive


Reading time ( words)

Engineered Materials Systems, a leading global supplier of conductive interconnect materials for circuit assembly applications, announces the introduction of its new EMS 618-15 Adhesive. The room temperature cure two-part conductive adhesive has been designed for circuit assembly applications.

EMS 618-15 is designed to cure in 24-hours at room temperature or rapidly at elevated temperatures. The material has a ten-to-one mix ratio and is available in a two syringe packaging system designed for use with static mix heads. EMS 618-15 forms high strength, high reliability conductive interconnects.

The EMS 618-15 conductive adhesive is the latest addition to Engineered Conductive Materials’ full line of conductive adhesives for circuit assembly applications.

For more information about the EMS 618-15 Room Temperature Cure Conductive Adhesive or to learn how Engineered Material Systems can define, develop and create an engineered material solution that is right for your company, visit www.emsadhesives.com.

About Engineered Material Systems

Engineered Materials Systems, Inc. (EMS) technology focus is on electronic materials for semiconductor, circuit assembly, photovoltaic, printer head, camera module, disk drive and photonics assembly product lines. The company creates continual improvements that will guide its customers into the future. For more information, visit www.emsadhesives.com.

Share

Print


Suggested Items

Research and Development Leads to Biogreen Coatings

11/29/2021 | Nolan Johnson, I-Connect007
In the November 2021 issue of SMT007 Magazine, we featured a pre-productronica interview with Phil Kinner of Electrolube, who shared a preview of the company’s newest products that the company planned to launch at the show in Munich. "This is the first show that we’ve been to in a while, and we have a couple of new products we are launching," said Kinner. "One is a thermal gap filler, designed in China by our Chinese team with a thermal conductivity of 6 watts per meter K, which is really decent. We also have a new conformal coating with a high degree of bio-renewable source materials."

Northrop Grumman: 3D Nanomaterials May Counter Gaps in Additive Supply Chain

10/22/2020 | Andy Shaughnessy, Design007 Magazine
The best technology is dead in the water if your domestic supply chain won’t support it. That was just one of the takeaways from Dr. Judy Dickson’s talk during the SMTA Additive Electronics TechXchange. In her presentation, titled “Advanced PWBs: A Collaboration Between Design, Operations, and the Supply Chain,” Dickson, a senior principal systems engineer at Northrop Grumman Mission Systems, laid out the many challenges her department faces in fielding HDI advanced packaging into the next decade. Most of these challenges are related to sourcing the necessary materials in the U.S.

Increase Traceability, Prevent Counterfeiting

08/25/2020 | I-Connect007 Editorial Team
Michael Ford, senior director of emerging industry strategy for Aegis Software and I-Connect007 columnist, speaks about the increasing importance of traceability in manufacturing and throughout the supply chain, including how it affects such areas as counterfeit components and inventory management.



Copyright © 2021 I-Connect007. All rights reserved.