Keysight Seminar Focuses on Signal/Power Integrity


Reading time ( words)

This free seminar will discuss the new features included in Keysight’s EEsof EDA simulation tools and how the software helps engineers focused on high-speed digital electronics solve their toughest design challenges. The seminar will look at all stages of the pre-layout, post-layout and measurement design flow.

Tools featured in the seminar include: ADS, ADS Controlled Impedance Line Designer (CILD), SI S-parameter analysis tools, and the ADS PCIe and USB test benches used with Keysight real-time oscilloscope certified test compliance software.

Attendees also will see a preview of the new power integrity PI Pro simulator with IR drop and decoupling capacitor optimization, available in upcoming release of ADS 2015.09. Registration is required to attend.

When:
July 14 and July 16

Where:
Agilent Technologies, 5301 Stevens Creek Boulevard, Santa Clara, CA, the Aristotle Room.

To register, click here. For additional information, visit www.keysight.com/find/eesof.

 

Share

Print


Suggested Items

Why We Simulate

04/29/2021 | Bill Hargin, Z-zero
When Bill Hargin was cutting his teeth in high-speed PCB design some 25 years ago, speeds were slow, layer counts were low, dielectric constants and loss tangents were high, design margins were wide, copper roughness didn’t matter, and glass-weave styles didn’t matter. Dielectrics were called “FR-4” and their properties didn’t matter much. A fast PCI bus operated at just 66 MHz. Times have certainly changed.

Bridging the Simulation Tool Divide

04/12/2021 | I-Connect007 Editorial Team
Todd Westerhoff of Siemens EDA recently spoke with the I-Connect007 Editorial Team about the divide between users of high-powered enterprise simulation tools and those who need a more practical tool for everyday use, and how Siemens is working to bridge the gap. Todd also shared his views on why so many engineers do not use simulation, as well as advice for engineers just getting started with simulation tools.

Barry Olney’s High-Speed Simulation Primer

04/09/2021 | I-Connect007 Editorial Team
The I-Connect007 editorial team recently spoke with Barry Olney of iCD about simulation. Barry, a columnist for Design007 Magazine, explains why simulation tools can have such a steep learning curve, and why many design engineers are still not using simulation on complex high-speed designs.



Copyright © 2021 I-Connect007. All rights reserved.